Hot search: 3KW electromag
Aluminum ingot
1T one belt tw
2T steel melt
IF induction furnace Q & A?
Safe operation of medium frequency induction heating furnace
1. Before starting the furnace, check whether the electrical equipment, water cooling system, sensor copper tube, etc. are in good condition, otherwise it is forbidden to open the furnace.
2 , furnace furnace melting loss exceeds the provisions should be repaired in time. It is strictly forbidden to smelt in the deep melt.
3 , power transmission and furnace should be responsible for the person, after the power transmission, it is strictly prohibited to touch the sensor and cable. The shifter is not allowed to leave the post without permission, pay attention to the sensor and the external situation.
4. When loading, check whether there are any inflammable, explosive and other harmful materials in the charge. If it should be removed in time, it is forbidden to directly add cold and wet materials to the molten steel. After the molten liquid is filled to the upper part, it is strictly forbidden to add large blocks. To prevent the cover.
5. When the furnace is repaired and the crucible is made, the iron filings and iron oxides are prohibited. The crucible must be dense.
6. The pouring site and the pit in front of the furnace should be free of obstacles and no water to prevent the molten steel from falling to the ground.
7. The molten steel is not allowed to be overfilled. When the hand is raised and poured, the two should cooperate with each other. The walking should be stable. Do not rush to stop. After pouring, the surplus steel should be poured into the designated place.
8. The medium frequency generator room should be kept clean. It is forbidden to bring inflammable and explosive materials and other sundries into the room. No smoking is allowed indoors.
Copyright© 2007-2013 NO.6 Electric Mall All Rights Reserved
